Common troubles and troubleshooting of feed extrud…

There are often some failures in the operation of the feed extruder, specifically the following situations: 1. The discharge port of the extrusion chamber does not discharge when processing soybeans. …

Causes and solutions of belt slipping in extruder

When the extruder is operating, the belt will slip. In fact, this is a very normal phenomenon. 1) The drive belt of the extruder is too loose, causing slipping; 2) The load of the extruder is too larg…

Fault analysis of power failure and overload of ex…

The extruder is an important process equipment in the press workshop. Due to its high temperature and high pressure operation, it has high requirements for the safe operation of workshop operators. If…

Basic structure and correct use of magnetron

Microwave energy is generated by microwave generator, which consists of microwave tube and microwave tube power supply. The function of microwave tube power supply (power supply or microwave source fo…